HS/MS ELM327 V1.5 Switch FORScan Bluetooth

Technical Details 1Latest ELM327 version for greater F.o.r.d compatibilit 2Manufactured modification to include a switch to connect to different CAN buse 3Designed for FORScan softwar 4Compatible with software venders; FORScan, Elmconfig, FF2 and FoCCCus, plus mor 4MS CAN bus and HS CAN bus suppor 5Drivers and instructions include Product Introduction One ELM327 OBDII OBD2 USB with switch. Designed for communicating with F.o.r.d, for Mazda, for Lincoln and for Mercury vehicles. With this cable and the one of the supported software vendors you can detected modules which are not visible for regula OBD2 scanners. This includes showing you trouble codes, PIDs, running tests and services procedures which are never displayed by other OBD2 scanners and a standard ELM327. Basic Features Reset fault /trouble codes / parameter ids (PIDs Change car configuration dat Run test Services procedure Program certain model Pin Configurations Switch position one: HS CAN - Occupies pins 6 and 1 Switch position two: MS CAN - Occupies pins 3 and 1 Supported Software FORSca Elmconfi FoCCCu FF Plus mor Modified EML Please note that many F.o.r.d and Mazda models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the regular HS CAN bus. In contrast to HS CAN bus, MS CAN bus is not supported by the stock ELM327, because MS CA is a manufacturer-specific solution and located on non-OBD2 pins. This ELM327 has been modified to allow it to implement the MS CAN bus. ELM327 supports HS CAN from the stock, because for Ford HS CAN completely matches to the OBD2 standards. It occupies pins 6 and 14. MS CAN bus occupies pins 3 and 11. Supported Vehicles All for Ford, for Mazda, for Lincoln, for Mercury vehicles that can be addressed using an ELM via an OBDII connector. Supported Protocols for FORD HS CA for FORD MS CA Other Details Cables fully tested on supported model before shipping. No responsibility can be accepted for any damage caused by the lead. Packing List 1 * ELM327 OBD2 bluetooth diagnostic interface